Exit Inspection-HVAC: Finish

**SITE SUPERVISOR**
When submitted, form responses are sent to the email addresses provided and then deleted.
IF YOU WISH TO RETAIN AND/OR SHARE THE INFORMATION,
YOU MUST ENTER THE APPROPRIATE EMAIL ADDRESS AND SEND.

HVAC: FINISH

Exit Inspection

Project

Builder

Inspection date

Furnace is installed per manufacturer’s instructions.

Yes No NA See Notes

AC coil is installed per manufacturer’s instructions.

Yes No NA See Notes

Coverings are removed from ductwork.

Yes No NA See Notes

All ductwork is connected.

Yes No NA See Notes

Grills are installed square and level. In vinyl areas grills are flush to floor and do not tilt more than 1/4 inch when stepped on.

Yes No NA See Notes

All grills in ceilings are fitted flush with ceiling and have proper sealing material.

Yes No NA See Notes

All other grills fit snugly.

Yes No NA See Notes

All filters are installed.

Yes No NA See Notes

HVAC units have been tested to verify correct airflow.

Yes No NA See Notes

Thermostats are square and level.

Yes No NA See Notes

Thermostats have been tested.

Yes No NA See Notes

Instruction and warranty manuals for thermostats, air conditioner, and heater have been placed in kitchen drawer to left of range.

Yes No NA See Notes

Air conditioning condensation unit is set level and operating.

Yes No NA See Notes

Condensation pump, if applicable, is clean, free of debris, and operating properly.

Yes No NA See Notes

For attic unit, condensation pan and drain pipe are free of any obstructions.

Yes No NA See Notes

Hot water tank vent pipe is installed.

Yes No NA See Notes

After gas inspection, the pressure gauges have been removed and the pipe capped.

Yes No NA See Notes

House has passed final HVAC inspection.

Yes No NA See Notes

House is clean and free of debris.

Yes No NA See Notes

Send to

Builder representative

Builder email

Subcontractor

Subcontractor representative

Subcontractor email (optional)

Copy to (optional)