Exit Inspection-HPH WaterSense: Indoor

Skip to content

WaterSense® Checklist

INDOOR WATER EFFICIENCY CRITERIA

Project

Builder

Date

Leaks

A pressure-loss test on all water supply lines detected no leaks

Yes/Pass/True No/Fail/False NA See Note

There are no visible water leaks from the hot water delivery system

Yes/Pass/True No/Fail/False NA See Note

There are no visible water leaks from toilets or urinals

Yes/Pass/True No/Fail/False NA See Note

There are no visible water leaks from bathroom faucets

Yes/Pass/True No/Fail/False NA See Note

There are no visible water leaks from kitchen faucets

Yes/Pass/True No/Fail/False NA See Note

There are no visible water leaks from showerheads

Yes/Pass/True No/Fail/False NA See Note

There are no visible water leaks from other fixtures or appliances

Yes/Pass/True No/Fail/False NA See Note

Service Pressure

Single-family: The pressure tank is installed and is set to 60 psi or less, OR

Yes/Pass/True No/Fail/False NA See Note

Single-family: A Pressure-Regulating Valve (PRV) is installed upstream of fixtures and pressure is set to 60 psi or less, OR

Yes/Pass/True No/Fail/False NA See Note

Single-family: A pressure test shows pressure at 60 psi or less and homebuilder has written documentation from the water supplier that pressure is 60 psi or less

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Multi-family:A pressure test shows the pressure at 60 psi or less

Yes/Pass/True No/Fail/False NA See Note

Hot Water Delivery

The hot water delivery system stores 0.5 gallons (1.9 liters) or less in any piping or maifold between the hot water source and any hot water fixture

Yes/Pass/True No/Fail/False NA See Note

The hot water delivery system is not based solely on a timer and/or a temperature sensor

Yes/Pass/True No/Fail/False NA See Note

The system is a demand-initiated recirculating system

Yes/Pass/True No/Fail/False NA See Note

When the hot water delivery system is engaged, there is a 10°F temperature increase before 0.6 gallons (2.3 liters) has been disbursed

Yes/Pass/True No/Fail/False NA See Note

Toilets

All toilets are WaterSense® labeled

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Flushing Urinals

All flushing urinals are WaterSense® labeled

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Bathroom Sink Faucets

All bathroom sink faucets are WaterSense® labeled

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

The bathroom sink faucet measured flow rate is a maximum of 1.5 gpm (Flow test maximum: 0.25 gallons)

Yes/Pass/True No/Fail/False NA See Note

Kitchen Sink Faucets

The kitchen sink faucet measured flow rate is a maximum of 2.2 gpm (Flow test maximum: 0.4 gallons)

Yes/Pass/True No/Fail/False NA See Note

Showerheads

All showerheads are WaterSense® labeled

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

The showerhead measured flow rate is a maximum 2.0 gpm water per shower compartment less than 2,160 square inches (Flow test maximum: 0.35 gallons/compartment)

Yes/Pass/True No/Fail/False NA See Note

There are separate controls for showerheads if the show compartment is greater than 2160 square inches

Yes/Pass/True No/Fail/False NA See Note

Dishwasher

The dishwasher is ENERGY STAR® qualified

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Clothes Washer

The clothes washer is ENERGY STAR® qualified

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

The clothes washer water factor is less than 6.0 gallons per cycle per cubic foot of capacity

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Evaporative Cooling System

The evaporative cooling system is not a once-through or single pass cooling system

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

The evaporative cooling system is not a system with continuous blowdown or bleedoff

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

The evaporative cooling system is not a system with timer-only mediated blowdown management

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

The evaporative cooling system uses a maximum of 3.5 galons (13.3 liters) of water per ton-hour of cooling

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

The evaporative cooling system has a maximum of three (3) blowdowns in 24 hours

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Blow-downs are controlled through conductivity or a basin temperature-based controller

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Water Softener

Water softeners are Certified to NSF/ANSI Standard 44, including voluntary efficiency rating standards in Section 7

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Drinking Water

Drinking water treatment systems are NSF/ANSI certified, with minimum efficiency rating of 85%

Yes/Pass/True No/Fail/False NA See Note Builder has and will provide the required documentation

Send to

Builder representative

Builder email

Copy to

Subcontractor

Subcontractor representative

Subcontractor email

Home

Contact Us

Company

Site Disclaimer
Site Terms of Service
Site Privacy Policy